Base Stabilization

Find a Contractor/Supplier

General Parameters & Advice

  • Spreader meters: Calibrated to ensure accurate spread rates of cementitious stabilizer placement
  • Water injection system: Calibrated to ensure correct water for foaming and/or to get mix close to optimum moisture content (gives highest density)
  • Binder injection system: Calibrated to achieve properties close to mix design and ensure enough binder in the mix to get good cohesion & strength
  • Milling drum: Zero on ground to get accurate slope readings during the work

Calibration Guidelines

  • Check mixing equipment for accuracy volumetrically during production to insure accuracy
  • A 10% tolerance from desired quantities is sufficient to verify that the equipment is properly calibrated